Maintenance products, accessories en parts for spa, swim spa and infrared sauna

Floculant can be used for cloudy water caused by micro-particles in the water. This product makes these particles larger, they will no longer escape filtration and the spa water will become completely clear again.
Carefully read the instructions for use on the packaging.

Makes dirty water crystal clear again.
Carefully read the instructions for use on the packaging.

Melpool TA plus alkalinityTA plus powder increases the total alkalinity (TA) of the water, which in turn stabilises the pH value. 150 g of this product per 10 m³ of water increases the TA by 10 PPM. Maintain the TA between 100 and 150 PPM. Attention: Do not dose more than 300 g/10 m³ per treatment. Dissolve the powder in a bucket of water and then distribute evenly over the water surface.

The very best water treatment product for your spa. If you choose AquaFinesse, you will enjoy wonderfully clear, clean and incredibly soft spa water every day. You also make an easy-to-use, time-saving and environmentally conscious choice. Everything you need to maintain your spa is in this AquaFinesse package.
Extends the life of your spa components
Provides unprecedented water quality
Provides ultimate convenience
Extremely time-savingContains no hazardous substances
Each set of AquaFinesse lasts between 3 and 6 months depending on the size of your spa.
Carefully read the instructions for use on the packaging.

Test strips for Aquachek Trutester. The pack contains 50 test strips.
Test the water quality of your spa for chlorine, pH, bromine and alkalinity.

Digital meter with 25 test strips
A very easy-to-use test set for measuring chlorine, pH and alkalinity. This photometer works with test strips that you only need to briefly hold in the water. The tester has a memory for the last 9 measurements. Comes with a manual and 25 test strips.

Quick-dissolving stabilised and hydrated disinfectant in granular form. Read the label and product information before use.
1. First regulate the alkalinity and pH of the water.
2. After pH adjustment, circulate the water intensively for at least 15 minutes before adding chlorine.
3. Remove the cushions from the jacuzzi to avoid staining.
4. Dissolve 15 g of chlorine granules per 1000 litres of water in a bucket of lukewarm water and add this solution to the jacuzzi water.
5. Run the pumps at maximum speed for 30 minutes.
6. Wait until the chlorine level is below 5 ppm before using the jacuzzi.

Slow-soluble chlorine for regular chlorine dosing.
CAUTION: Do not put directly into the water. Always use a floating chlorine distributor.

Floating chlorine diffuser with adjustable chlorine flowSize: 23 x 13 x 10 cmColour: light blue

Bucket 22L with a lid, suitable for soaking/washing your Spa filters.

Spa Tube Flush is an eco-friendly product that removes stubborn dirt in the pipes of your jacuzzi with ease. Use the product before changing the water.
Instructions for use:
1. Make sure there is enough water in the jacuzzi to allow the pumps to circulate the water.
2. Remove the filters
3. Add 25 ml/1000 l Spa Tube Flush to the jacuzzi water.
4. Then open ALL jets and ALL three-way valves and run the pumps on high speed for 30 minutes or on low speed overnight.
5. Drain all the water from your jacuzzi.
6. Clean the jacuzzi tub.
7. Install clean or new filters.
8. Fill the jacuzzi with tap water and balance as at start-up.
Carefully read the instructions for use on the packaging.

Cover Clean/Cover Shine cleans and protects any vinyl jacuzzi or swim spa cover.
Keeping the vinyl of the cover clean is an important part of the periodic maintenance of your jacuzzi or swim spa. Therefore, clean the cover every three months and use a product such as Cover Clean to protect against UV rays and other weather influences.
Carefully read the instructions for use on the packaging.

Fix-a-Leak 1LSpa water leaks are tricky and sometimes expensive to repair. With FIX-A-LEAK, the repair costs can be minimised by following the instructions on the bottle.Normally, FIX-A-LEAK will seal holes up to 3 mm in diameter.

The Filter Cartridge Clean Spray is ideal for cleaning filter bags and cartridge filters removing oil, grease and calcium from filter bags and cartridge filters in minutes.
Carefully read the instructions for use on the packaging.
Instructions for use:
Cleaning filter bags: Spray the filter bag and leave for 3 to 6 minutes before washing in the washing machine at 40°C on the long cycle for delicate laundry with a dash of liquid detergent. DO NOT use fabric softener or tumble dry.
Cleaning paper cartridge filters: Spray the cartridge filter and leave for 3 to 6 minutes. Rinse the filter thoroughly with clean water.
Carefully read the instructions for use on the packaging.

The Spa Cartridge Cleaner is ideal for cleaning cartridge filters removing oil, grease and calcium from the filter bags and cartridge filters in minutes.
Carefully read the instructions for use on the packaging.

The wall cleaner easily removes dirt, algae and bacteria on the inside of the jacuzzi or swim spa tub.
How to use. Apply product undiluted using a soft sponge, no need to rinse.
Carefully read the instructions on the packaging.

• For removing floating debris.
• Unique circular design adapted to the contours of the spa.
• Rubber edge prevents damage to the spa.
• For manual use or with a standard telescopic handle.

The simple and inexpensive solution for cleaning your spa or pool.The ManoVac works without batteries, pump or water connection, but by a manual pump system.All the dirt such as sand, pebbles, leaves and grass on the bottom of the filter part needs to be rinsed clean. This can be done under the tap.The ManoVac is the only vaacum cleaner that really works. PropertiesMade of state-of-the-art materials and is light, portable, easy to use and durable

Small Pool and Spa jet Vacuum.Vacum for removing dig from the pool and/or the spa.Reusable leag bag included.Garden hose connector included